Huawei Quidway S6500 Series Operation Manual page 300

Operation Manual - Multicast Protocol
Quidway S6500 Series Ethernet Switches
Table 3-3 Configuring the maximum response time
Configure the maximum response
time
Restore the default setting
By default, the maximum response time is 10 seconds.
3.2.4 Configuring Aging Time of Multicast Group Member
This task is to manually set the aging time of the multicast group member port. If the
switch receives no multicast group report message during the member port aging time,
it will transmit the specific query message to that port and starts a maximum response
timer.
Perform the following configuration in system view.
Table 3-4 Configuring aging time of the multicast member
Configure aging time of the multicast
member
Restore the default setting
By default, the aging time of the multicast member is 260 seconds.
3.3 Displaying and debugging IGMP Snooping
After the above configuration, execute display command in any view to display the
running of the IGMP Snooping configuration, and to verify the effect of the configuration.
Execute reset command in user view to reset the IGMP Snooping statistic information.
Execute debugging command in user view to debug IGMP Snooping configuration.
Table 3-5 Displaying and debugging IGMP Snooping
Display the information about current IGMP
Snooping configuration
Display
received and sent messages
Display IP/MAC multicast group information
in the VLAN
Operation
Operation
Operation
IGMP Snooping statistics
Huawei Technologies Proprietary
Chapter 3 IGMP Snooping Configuration
Command
igmp-snooping
seconds
undo IGMP-snooping max-response-time
igmp-snooping
seconds
undo igmp-snooping host-aging-time
display
configuration
of
display igmp-snooping statistics
display
[ vlan vlanid ]
3-6
max-response-time
Command
host-aging-time
Command
igmp-snooping
igmp-snooping group