Set The Destination Address Of Trap; Set Lifetime Of Trap Message; Set Syslocation - Huawei Quidway S6500 Series Operation Manual

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches

5.3.4 Set the Destination Address of Trap

You can use the following commands to set or delete the destination address of the
trap.
Perform the following configuration in system view.
Table 5-5 Set the destination address of trap
Operation
Set the
address of trap
Delete the destination
address of trap

5.3.5 Set Lifetime of Trap Message

You can use the following command to set lifetime of Trap message. Trap message that
exists longer than the set lifetime will be dropped.
Perform the following configuration in system view.
Table 5-6 Set the lifetime of Trap message
Set lifetime of Trap message
Restore lifetime of Trap message
By default, the lifetime of Trap message is 120 seconds.

5.3.6 Set SysLocation

The sysLocation is a management variable of the MIB system group, used for
specifying the location of managed devices.
You can use the following commands to set the sysLocation.
Perform the following configuration in system view.
snmp-agent target-host trap address udp-domain
destination host-addr
securityname community-string [ v1 | v2c | v3
[ authentication | privacy ] ]
undo snmp-agent target-host host-addr securityname
community-string
Operation
Huawei Technologies Proprietary
5-5
Chapter 5 SNMP Configuration
Command
[ udp-port udp-port-number
Command
snmp-agent trap life seconds
undo snmp-agent trap life
] params