Huawei Quidway S6500 Series Operation Manual page 123

Operation Manual - Network Protocol
Quidway S6500 Series Ethernet Switches
By default, IPX RIP does not import static routes.
Note that RIP imports only active static routes; inactive static routes are neither
imported nor forwarded.
7.2.6 Configure IPX SAP
After IPX is enabled on VLAN interfaces, the system automatically enables SAP. You
can configure SAP parameters and service information as needed.
Enable/Disable SAP
Configure the update interval of IPX SAP
Configure the aging period of IPX SAP
Configure the size of IPX SAP update packets
Configure GNS reply of IPX SAP
Configure IPX static service entries
Configure the length of service information reserve-queues
I. Enable/Disable SAP
On a VLAN interface, SAP is enabled as soon as IPX is enabled on the interface. You
can enable/disable SAP with the following commands.
Perform the following configuration in VLAN interface view.
Table 7-11 Enable/Disable SAP
Disable IPX SAP
Enable IPX SAP
II. Configure the update interval of IPX SAP
In a huge network, one IPX SAP broadcast consumes enormous bandwidth resources.
By configuring an appropriate SAP update interval, you can reduce the bandwidth
waste.
Perform the following configuration in system view.
Table 7-12 Configure the update interval of IPX SAP
Configure the update interval of IPX
SAP
Restore the default update interval of
IPX SAP
Operation
Operation
Huawei Technologies Proprietary
7-7
Chapter 7 IPX Configuration
Command
ipx sap disable
undo ipx sap disable
Command
ipx sap timer update seconds
undo ipx sap timer update