Error Packets Monitoring Configuration Example - Huawei Quidway S6500 Series Operation Manual

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches
Table 3-14 Configure error packets monitoring
Number
1
2
3
4
To cancel related configuration, use the qe monitor errpkt none command.

3.7.2 Error Packets Monitoring Configuration Example

I. Network requirements
Enable error packets monitoring on Ethernet4/0/1 interface and only the packets
that are of runt type are concerned.
Set the interval for detecting error packets to 50 seconds.
II. Configuration procedure
1) Enter system view.
<Quidway> system-view
[Quidway]
2) Set the interval for detecting error packets to 50 seconds.
[Quidway] qe monitor errpkt check-time 50
3) Enter the Ethernet interface view of Ethernet4/0/1.
[Quidway] interface ethernet 4/0/1
Operation
Enter the <Quidway>
system view system-view
Set the interval [Quidway] qe monitor
for detecting errpkt
error packets interval
[Quidway]
Enter an
{
Ethernet
interface_num
interface view
interface_name }
[Quidway-EthernetX/0/X
] qe monitor errpkt
{ runt | all }
Enable error
packets or
monitoring
[Quidway-GigabitEthern
etX/0/X]
errpkt { runt | all }
Huawei Technologies Proprietary
Command
check-time
interface
interface_type
|
qe monitor
3-11
Chapter 3 Device management
Remarks
–
Optional. Defaults to 5
seconds.
The type of the interface
can be Ethernet
GigabitEthernet.
prompt of an Ethernet
interface view differs with
the type of the selected
interface.
Required.
If you specify the keyword
runt in these
commands, the switch only
detects error packets that
are of runt type on current
interface.
If you specify the keyword
all, the switch detects all
error packets on current
interface.
or
The
two