Huawei Quidway S6500 Series Operation Manual page 135

Operation Manual - Network Protocol
Quidway S6500 Series Ethernet Switches
The round robin polling is enabled with the display current-configuration
command.
Multiple equivalent service entries are available for the service request. The
service entries are considered equivalent only when they have the same RIP ticks ,
RIP hop count, SAP hop count and SAP preference.
IV. Troubleshoot IPX routing management
Fault: The current switch receives the routing information from a neighbor device, but
the route cannot be found on the current switch using the display ipx routing-table
verbose command.
Troubleshooting:
Use the display current-configuration command to view the maximum dynamic
route limit for each destination network number; it can be the one configured using
the command ipx route max-reserve-path or the default setting, that is, 4.
Use the display ipx routing-table verbose command to check that the number of
the existing dynamic routes to the destination network is under the limit.
If the number of dynamic route entries with the destination network number is
beyond the limit, use the ipx route max-reserve-path command to set a higher
limit to accommodate new dynamic route information.
Huawei Technologies Proprietary
7-19
Chapter 7 IPX Configuration