Huawei Quidway S6500 Series Operation Manual page 160

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
Enable the interface to send RIP update packet
Disable the interface to send RIP update packet
The undo rip work command and the undo network command have similar but not all
the same functions. Neither of the two commands configures interface receiving or
sending RIP route. But in the undo rip work status, other interfaces still forward the
route of the interface applying this command, while in the undo network status, other
interface will no more forward the route of the interface applying this command, and it
seems that this interface has been removed.
In addition, rip work is functionally equivalent to both rip input and rip output
commands.
By default, all interfaces except loopback interfaces both receive and transmit RIP
update packets.
3.2.8 Disabling host route
In some special cases, the router can receive a lot of host routes from the same
segment, and these routes are of little help in route addressing but consume a lot of
network resources. Routers can be configured to reject host routes by using undo
host-route command.
Perform the following configurations in RIP view.
Table 3-8 Disabling host route
Enable receiving host route
Disable receiving host route
By default, the router receives the host route.
3.2.9 RIP-2 Route Aggregation Function
The so-called route aggregation means that different subnet routes in the same natural
network can be aggregated into one natural mask route for transmission when they are
sent to the outside (i.e. other network). Route aggregation can be performed to reduce
the routing traffic on the network as well as to reduce the size of the routing table.
Operation
Operation
Huawei Technologies Proprietary
3-7
Chapter 3 RIP Configuration
Command
rip output
undo rip output
Command
host-route
undo host-route