Huawei Quidway S6500 Series Operation Manual page 151

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
Table 2-3 Configuring the default preference of static routes
Configure the default preference
value of static routes
Restore the default value
By default, its value is 60.
2.2.4 Deleting All the Static Routes
You can use the undo ip route-static command to delete one static route. S6500
series ethernet switches also provide a special command for you to delete all static
routes at one time, including the default routes.
Perform the following configuration in system view.
Table 2-4 Deleting all static routes
Delete all static routes
2.3 Displaying and Debugging Static Route
After the above configuration, execute display command in any view to display the
running of the Static Route configuration, and to verify the effect of the configuration.
Table 2-5 Displaying and debugging the routing table
View routing table summary
View routing table details
View the detailed information of a
specific route
View the route information in the
specified address range
View the route filtered through specified
basic access control list (ACL)
View the route information that through
specified ip prefix list
Operation
Operation
Operation
Huawei Technologies Proprietary
Chapter 2 Static Route Configuration
Command
ip route-static
default-preference-value
undo ip route-static default-preference
delete static-routes all
display ip routing-table
display ip routing-table verbose
display ip routing-table ip_address
[ mask ] [ longer-match ] [ verbose ]
display ip routing-table ip_address1
mask1 ip_address2 mask2 [ verbose ]
display ip
{ acl-number | acl-name } [ verbose ]
display ip
ip-prefix-name [ verbose ]
2-4
default-preference
Command
Command
routing-table
routing-table ip-prefix
acl