Huawei Quidway S6500 Series Operation Manual page 206

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
IS-IS configuration includes:
Enabling IS-IS and Entering the IS-IS View
Setting Network Entity Title (NET)
Enabling IS-IS on the Specified Interface
Setting IS-IS Link State Routing Metric
Setting the Hello Packet Broadcast Interval
Setting the CSNP Packet Broadcast Interval
Setting the LSP Packet Interval
Setting LSP Packet Retransmission Interval
Setting the Hello dead Interval
Setting Priority for DIS Election
Setting Interface Circuit Level
Setting IS-IS Authentication
Setting the Mesh Group of the Interface
Setting Router Type
Setting to Generate Default Route
Setting Summary Route
Setting Overload Flag Bit
Setting to discard the LSPs with Checksum Errors
Setting to Log the Peer Changes
Setting LSP Refresh Interval
Setting Lifetime of LSP
Setting SPF Calculation in Slice
Setting SPF to Release CPU Actively
Setting SPF Computing Interval
Enabling/Disabling the Interface to Send Packets
Configuring IS-IS to import Routes of Other Protocols
Configuring IS-IS Route Filtering
Setting the Preference of IS-IS Protocol
Resetting All the IS-IS Data Structure
Resetting the Specified IS-IS Peer
5.2.1 Enabling IS-IS and Entering the IS-IS View
To run IS-IS protocol, you need to create an IS-IS routing process.
After creating an IS-IS routing process in system view, you should also activate this
routing process at an interface that may correlate with another router. After that, the
IS-IS protocol can be started and run.
Perform the following configurations in system view.
Huawei Technologies Proprietary
5-5
Chapter 5 Integrated IS-IS Configuration