Huawei Quidway S6500 Series Operation Manual page 207

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
Table 5-1 Enabling IS-IS and entering the IS-IS view
Enable the IS-IS and enter the IS-IS view
Cancel the specified IS-IS routing process
The tag parameter identifies the IS-IS process. In present version, just one IS-IS
process is allowed.
By default, the IS-IS routing process is disabled.
5.2.2 Setting Network Entity Title (NET)
Network Entity Titles (hereafter referred to as NETs) defines the current IS-IS area
address and the system ID of the router.
Perform the following configurations in IS-IS view.
Table 5-2 Setting Network Entity Title (NET)
Set Network Entity Title (NET)
Delete a NET
The format of parameter net is X...X.XXXXXXXXXXXX.XX, among which the first
"X...X" is the area address, the twelve Xs in the middle is the System ID of the router.
The last XX should be 00.
Caution:
A router can be configured with different area addresses. However the routers in the
same area should be configured with the same area address. Every router has a
unique System ID.
5.2.3 Enabling IS-IS on the Specified Interface
After enabling IS-IS, you need to specify on which Interfaces the IS-IS will be run.
Perform the following configurations in Interface view.
Operation
Operation
Huawei Technologies Proprietary
5-6
Chapter 5 Integrated IS-IS Configuration
Command
isis [ tag ]
undo isis [ tag ]
Command
network-entity net
undo network-entity net