Layer 3 Connectivity Detection Configuration Task - Huawei Quidway S6500 Series Operation Manual

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches

3.5.1 Layer 3 Connectivity Detection Configuration Task

Note:
Before performing this configuration, make sure the physical link between the local
peer and the remote peer is correct, and the related VLAN interfaces are assigned with
an IP addresses.
The following table describes the configuration tasks of layer 3 connectivity detection.
Table 3-12 Configure Layer 3 connectivity detection
Number
1
2
3
4
To cancel the related configuration, use the corresponding undo command.
Operation
Enter system
<Quidway> system-view
view
Enter an [Quidway]
Ethernet { interface_type interface_num |
interface view interface_name }
Enable Layer 3
[Quidway-EthernetX/0/X] uplink
connectivity
monitor ip ip-addr
detection and
specify the IP or
address of the
[Quidway-GigabitEthernetX/0/X]
device to be
uplink monitor ip ip-addr
detected.
View
information
about Layer 3
connectivity [Quidway-EthernetX/0/X]
between the display uplink monitor
local device
and the remote
device.
Huawei Technologies Proprietary
Command
interface
3-8
Chapter 3 Device management
Remarks
–
The type of the
interface can
Ethernet
GigabitEthernet.
The prompt of an
Ethernet interface
view differs with the
type of the selected
interface.
Required
You can execute
the display
command at any
view.
be
or