Huawei Quidway S6500 Series Operation Manual page 55

Operation Manual - Port
Quidway S6500 Series Ethernet Switches
1.4 Ethernet Port Configuration Example
I. Networking requirements
Switch A is connected to Switch B via the Trunk port Ethernet1/0/1. Configure the Trunk
port with default VLAN ID, so that: when receiving the packets without VLAN Tag, the
port can forward them to the member ports belonging to the default VLAN; when it
sending the packets with VLAN Tag and the packet VLAN ID is the default VLAN ID, the
Trunk port remove the packet VLAN Tag and forward the packet.
II. Networking diagram
Switch A
Figure 1-1 Configure the default VLAN for a trunk port
III. Configuration procedure
The following configurations are used for Switch A. Please configure Switch B in the
similar way.
# Enter the Ethernet port view of Ethernet1/0/1.
[Quidway] interface ethernet1/0/1
# Set the Ethernet1/0/1 as a trunk port and allows VLAN 2, 6 through 50, and 100 to
pass through.
[Quidway-Ethernet1/0/1] port link-type trunk
[Quidway-Ethernet1/0/1] port trunk permit vlan 2 6 to 50 100
# Create the VLAN 100.
[Quidway] vlan 100
# Configure the default VLAN ID of Ethernet1/0/1 as 100.
[Quidway-Ethernet1/0/1] port trunk pvid vlan 100
1.5 Ethernet Port Troubleshooting
Fault: Default VLAN ID configuration on trunk port or hybrid port failed.
Troubleshooting: Take the following steps.
Switch B
Huawei Technologies Proprietary
1-13
Chapter 1 Ethernet Port Configuration