Huawei Quidway S6500 Series Operation Manual page 194

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
By default, OSPF TRAP function is disabled. That is, the switch does not send TRAP
packets when any OSPF process is abnormal. The configuration is valid to all OSPF
processes if you do not specify a process ID.
For detailed configuration of SNMP TRAP, refer to the module "System Management"
in this manual.
4.2.29 Resetting the OSPF Process
If the undo ospf command is executed on a router and then the ospf command is used
to restart the OSPF process, the previous OSPF configuration will lose. With the reset
ospf command, you can restart the OSPF process without losing the previous OSPF
configuration.
Perform the following configuration in user view.
Table 4-31 Resetting the OSPF process
Reset the OSPF process
Resetting the OSPF process can immediately clear the invalid LSAs, make the
modified Router ID effective or re-elect the DR and BDR.
4.3 Displaying and Debugging OSPF
After the above configuration, execute display command in any view to display the
running of the OSPF configuration, and to verify the effect of the configuration. Execute
debugging command in user view to debug the OSPF module.
Table 4-32 Displaying and debugging OSPF
Display the brief information of the
OSPF routing process
Display OSPF statistics
Display LSDB information of OSPF
Display OSPF peer information
Display OSPF next hop information
Display OSPF routing table
Operation
Operation
Huawei Technologies Proprietary
Command
reset ospf [ statistics ] { all | process-id }
Command
display ospf [ process-id ] brief
display ospf [ process-id ] cumulative
display ospf [ process-id ] [ area-id ] lsdb
[ brief | [ asbr | ase | network | nssa | router
| summary ] [ ip-address ] [ originate-router
ip-address | self-originate ] ]
display ospf [ process-id ] peer [ brief ]
display ospf [ process-id ] nexthop
display ospf [ process-id ] routing
4-26
Chapter 4 OSPF Configuration