Huawei Quidway S6500 Series Operation Manual page 75

Operation Manual - VLAN
Quidway S6500 Series Ethernet Switches
1.4.2 Create a Protocol-Based VLAN on the Specified Port
Perform the following configuration in Ethernet port view.
Table 1-10 Create/delete a Protocol-Based VLAN on the Specified Port
Create a Protocol-Based VLAN on the
Specified Port
Delete a Protocol-Based VLAN on the
Specified Port
Caution:
The port must be of hybrid and must belong to the protocol-based VLAN.
You can only configure the same protocol type and encapsulation type in the same
VLAN.
You cannot apply the protocol type and encapsulation format in different VLANs to
the same port.
When a protocol is applied in a VLAN, this VLAN cannot be deleted.
When the protocol of the VLAN is applied on the port, this VLAN cannot be deleted
from the port.
When the protocol of the VLAN is applied on the port, this protocol cannot be
deleted from the VLAN.
1.4.3 Create a Protocol-Based VLAN on the Specified Card
Perform the following configuration in system view.
Table 1-11 Create/Delete a Protocol-Based VLAN on the Specified Card
Create a Protocol-Based VLAN on the
Specified Card
Delete a Protocol-Based VLAN on the
Specified Card
Operation
Operation
Huawei Technologies Proprietary
1-7
Chapter 1 VLAN Configuration
Command
port hybrid protocol-vlan vlan vlan-id
{ protocol-index [ to protocol-end ] | all }
undo port hybrid protocol-vlan vlan
vlan-id { protocol-index
protocol-end ] | all }
Command
protocol-vlan
{ protocol-index [ to protocol-end ] | all }
slot slot-num
undo protocol-vlan
{ protocol-index [ to protocol-end ] | all }
slot slot-num
[ to
vlan vlan-id
vlan vlan-id