Display This - H3C s3600 series Command Manual

If the switch is not a unit of a fabric, this command displays the startup configuration file information
of the current switch no matter whether you have specified the unit-id argument or not.
If the switch is a unit of a fabric, without unit-id specified, this command displays the startup
configuration file information of all the units in the fabric; with unit-id specified, this command
displays the startup configuration file information of the specified unit.
Related commands: startup saved-configuration.
Examples
# Display the startup configuration file information of the current switch, which is not in any fabric.
<Sysname> display startup
UNIT1:
Current Startup saved-configuration file:
Next main startup saved-configuration file:
Next backup startup saved-configuration file:
Bootrom-access enable state:
Table 1-2 Description on the fields of the display startup command
Field
Current Startup
saved-configuration file
Next main startup
saved-configuration file
Next backup startup
saved-configuration file
Bootrom-access enable state

display this

Syntax
display this [ by-linenum ]
View
Any view
Parameters
by-linenum: Displays configuration information with line numbers.
The configuration file used for the current startup
The main configuration file used for the next startup
The backup configuration file used for the next startup
Whether you can use the user-defined password to access the
Boot ROM:
enabled indicates you can access the Boot ROM with the
user-defined password.
disabled indicates you cannot access the Boot ROM with the
user-defined password.
For related information, refer to the startup bootrom-access
enable command in the File System Management part of the
manual.
1-10
flash:/config.cfg
flash:/config.cfg
flash:/backup.cfg
enabled
Description