Configuring A Trunk-Port-Based Vlan - H3C S5500-SI Series Operation Manual

Operation Manual – VLAN
H3C S5500-SI Series Ethernet Switches
To do...
Enter system view
Enter VLAN view
Add an Access port
to the current VLAN
Follow these steps to configure the Access-port-based VLAN in Ethernet port view/port
group view:
Enter system view
Enter
Ethernet
port view
or port
group
view
Configure the port link
type as Access
Add the current Access
port to a specified VLAN
Note:
To add an Access port to a VLAN, make sure the VLAN already exists.

1.4.3 Configuring a Trunk-Port-Based VLAN

A Trunk port may belong to multiple VLANs, and you can only perform this configuration
in Ethernet port view or port group view.
Follow these steps to configure the Trunk-port-based VLAN:
Use the command...
system-view
vlan vlan-id
port interface-list
To do...
system-view
Enter
interface interface-type
Ethernet port
interface-number
view
port-group { manual
Enter port
port-group-name |
group view
aggregation agg-id }
port link-type access
port access vlan vlan-id
—
Required
If the specified VLAN does not exist,
this command be created first
creates the VLAN before entering its
view.
Required
By default, system will add all ports
to VLAN 1.
Use the command...
1-8
Chapter 1 VLAN Configuration
Remarks
Remarks
—
Use either command
In Ethernet port view, the
subsequent
configurations only apply
to the current port; In port
group view, the
subsequent
configurations apply to all
ports in the port group.
Optional
The link type of a port is
Access by default.
Optional
By default, all Access
ports belong to VLAN 1.