Injector side connec-
tor
Injector intermediate
harness
Throttle valve
Equipment side connector
control servo
GDI –
On-vehicle Service
INJECTOR CHECK
1. Disconnect the injector intermediate harness connector.
2. Measure the resistance between each of the terminals.
Standard value: 0.9 – 1.1 Ω (at 20 C)
Injector
No.1 cylinder
No.2 cylinder
No.3 cylinder
No.4 cylinder
3. Connect the injector intermediate harness connector.
THROTTLE VALVE CONTROL SERVO CHECK
Operation Check
1. Disconnect the air intake hose from the throttle body.
2. Turn on the ignition switch.
3. Check that the throttle valve opens or closes in response
to the accelerator pedal depression.
Check of Coil Resistance
1. Disconnect the throttle valve control servo connector.
2. Measure resistance between the throttle valve control
servo connector terminals.
Standard value:
Terminals to be measured
Intake
1 – 3
manifold
2 – 4
3. Check that there is no continuity between the terminals
and body.
CLUTCH SWITCH CHECK
1. Disconnect the connector.
2. Check for continuity between the terminals of the switch.
Measurement conditions
When clutch pedal is depressed.
When clutch pedal is not depressed.
PURGE CONTROL SOLENOID VALVE CHECK
Refer to GROUP 17 – Emission Control System.
EGR VALVE CHECK
Refer to GROUP 17 – Emission Control System.
13A-109
Measurement terminal
1 – 2
3 – 4
5 – 6
7 – 8
Resistance value (Ω)
1.35 – 1.65 (at 20 C)
Terminal No.
1
2