INSPECTION PROCEDURE FOR TROUBLE SYMPTOMS
INSPECTION PROCEDURE 27
Accelerator pedal position switch system
The accelerator pedal position switch detects that the accelerator pedal is fully closed,
and sends a signal to the engine-ECU. The engine-ECU controls idle speed, based
on this signal.
Check the accelerator pedal position switch. (Refer to P.13A-11.)
Measure at accelerator pedal position sensor connector A-103.
D Disconnect the connector, and measure at the harness side.
D Voltage between terminal 4 and earth
(Ignition switch: ON)
OK: 4 V or more
D Continuity between terminal 5 and earth
OK: Continuity
Check the following connector: A-103
Check trouble symptom.
GDI <4G6> -
GDI <4G6> -
OK
OK
OK
Troubleshooting
Troubleshooting
Probable cause
D Maladjustment of the accelerator cable
D Maladjustment of the accelerator pedal position switch
D Open circuit or short-circuited harness wire in the
accelerator pedal position switch system, or poor
connector contact
D Malfunction of the engine-ECU
NG
Replace the accelerator pedal position sensor assembly.
NG
Check the following connectors: A-27, B-51, B-52
OK
Check trouble symptom.
NG
Check the harness wire between the engine-ECU and accelerator
pedal position sensor 1 (1st channel).
OK
NG
Repair
NG
Replace the engine-ECU.
13A-7
NG
Repair
NG
Repair