Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 929

51-20
Three dia. MARK
Licence lamp garnish
SPACE STAR MARK
EXTERIOR –
Licence lamp garnish end line
Trunk lid press line
1. Clean the mark installation surfaces on the body with
unleaded petrol.
2. Peel off the backing paper from the reverse side of the
marks, and then attach the marks to the vehicle body
so that they fit properly into position.
Caution
When
temperature should be 20 – 38 C and the air should
be completely free from dust.
If the surrounding temperature is lower than 20 C,
the marks and the places on the body where the marks
are to be attached should be heated to 20 – 38 C.
Marks
Licence lamp garnish centre
Trunk lid end line
24
45
attaching the marks,
Unit: mm
the surrounding