Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 881

42-38
Door delta
sash
Spline
Guide
Drum
Spline
BODY –
REMOVAL SERVICE POINTS
AA
Caution
Be careful when handling the power window motor
assembly, as the force of the spring may cause the wires
to pull out of the drum.
AB
1. Remove the door outer opening weatherstrip from the
door delta sash only.
2. Remove the door delta sash mounting screws, and then
remove the door delta sash from the door panel.
Door outer
opening
weatherstrip
INSTALLATION SERVICE POINTS
AA POWER WINDOW MOTOR ASSEMBLY/WINDOW
If the guide spline and the power window motor spline are
not meshed when combining the guide and the power window
motor, slide the glass bracket to turn the drum and mesh
the drum and drive shaft spline.
DRUM AND REGULATOR WIRE INSTALLATION
PROCEDURE
1. Place the drum, guide and regulator on a work bench
as shown in the illustration.
(1) Place the guide so that the slits are facing upward.
(2) Place the regulator so that the glass bracket is facing
Door
POWER WINDOW MOTOR ASSEMBLY
DOOR DELTA SASH REMOVAL
REGULATOR ASSEMBLY
downward. Position the glass bracket so that glass
is in the fully-open position.