Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 232

FRONT AXLE -
A
A
Drive Shaft
REASSEMBLY SERVICE POINTS
The following drive shaft reassembly procedures have been
established. Items other than those given below are the same
as before.
"AA DYNAMIC DAMPER/DAMPER BAND/T.J. BOOT
INSTALLATION
Install the dynamic damper in the position shown in the
illustration.
Items
2000 M/T
A/T
2400
"BA SPIDER ASSEMBLY/T.J. CASE INSTALLATION
After applying the specified grease to the T.J. case, insert
the drive shaft and apply grease one more time.
Specified grease: Repair kit grease
Amount to use:
<2000> 110 g
<2400> 140 g
NOTE
The grease in the repair kit should be divided in half for
use, respectively, at the joint and inside the boot.
Caution
The drive shaft joint uses special grease. Do not mix
old and new or different types of grease.
" A T.J. BOOT BAND (SMALL)/T.J. BOOT BAND
G
(LARGE) INSTALLATION
Set the T.J. boot bands at the specified distance in order
to adjust the amount of air inside the T.J. boot, and then
tighten the T.J. boot bands securely.
Standard value (A):
<2000> 82 ± 3 mm
<2400> 81 ± 3 mm
26-5
A
L.H. R.H.
215 mm -
215 mm 395 mm
215 mm -