Fan Controller Check <Gdi; Fan Control Relay Continuity Check <Gdi - Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement

14-10
Fan control relay
ENGINE COOLING –
FAN CONTROLLER CHECK <GDI>
1. Disconnect the condenser fan motor connector.
2. Start the engine and run it at idle.
3. Turn the A/C switch to ON and maintain the coolant
temperature at 80 C or less.
4. When
controller-side connector terminals, check that the value
changes repeatedly as indicated by (1) – (3) below.
(1) 0 V
(2) 8.2
(3) Battery voltage
5. If the voltage does not repeatedly change as indicated,
replace the radiator fan motor and the fan controller
assembly.
FAN CONTROL RELAY CONTINUITY CHECK
<GDI>
Battery voltage
When current is not
supplied
When
supplied
On-vehicle Service
measuring the voltage
2.6 V
2.6 V
Terminal No.
1 2
current is
14100610011
between the fan
14100620014
3 5