Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 907

Hide thumbs Also See for Space Runner 1999:

Table of Contents

verification hole

REMOVAL SERVICE POINTS

1. Close the roof lid glass fully.

2. Insert a flat-tipped screwdriver, place it on the tab, and

3. Lower sunroof-ECU and slide to left.

Remove the grommet. Tie a cord to the end of the drain hose,

wind tape around it so that there is no unevenness, and pull

the drain hose out into the wheel house.

INSTALLATION SERVICE POINTS

1. Tie the cord that was used during removal to the end

2. Pull the cord to pull through the drain hose

3. Make the protrusion from the drain hose grommet as shown

1. Fully close the roof lid glass.

2. Turn the gear of the sunroof-ECU until the two mating

3. Insert a flat-tipped screwdriver, place it on the tab, and

SUNROOF-ECU REMOVAL

then press it to the right.

DRAIN HOSE REMOVAL

AA DRAIN HOSE INSTALLATION

of the drain hose, and wind tape around it so that there

is no unevenness.

in the illustration.

BA SUNROOF-ECU INSTALLATION

marks are aligned.

press it to the right, being careful not to pinch wiring.

Show Quick Links

Chapters

Table of Contents