11C-34
ENGINE ASSEMBLY
REMOVAL AND INSTALLATION
Caution
Mounting locations marked by * should be provisionally tightened, and then fully tightened after
placing the vehicle horizontally and loading the full weight of the engine on the vehicle body.
Pre-removal and Post-installation Operation
D
Fuel Discharge Prevention (Refer to GROUP 13D
- On-vehicle Service.) <Pre-removal only>
D
Engine Cover Removal and Installation
D
Under Cover Removal and Installation
D
Engine Coolant Draining and Supplying
16
15
14
Removal steps
1. Drive belt (Power steering and
A/C)
2. Engine harness connector
3. Earth cable connection
4. Accelerator cable connection
5. Alternator connector
6. Power steering hose clamp
AA"
7. A/C compressor
AB"
8. Power steering oil pump
9. Vacuum hose connection
ENGINE <4G6-MPI> -
3
5 Nm
9
13
4
12
2
67 Nm
11
57 Nm
10
16
98 - 118 Nm*
Engine Assembly
D
Hood Removal and Installation
D
Transmission Assembly Removal and Installation
D
Drive Belt Tension Adjustment (Refer to P.11C-6.)
<Post-installation only>
D
Accelerator Cable Adjustment <Post-installation only>
2
5
17
10. Brake booster vacuum hose
connection
11. Heater hose connection
12. Fuel return hose connection
13. Fuel pressure hose connection
14. Power steering oil reservoir
AC" "CA 15. Engine mount bracket
"BA 16. Engine mount stopper
AD" "AA 17. Engine assembly
39 Nm
6
39 Nm
8
7
1