33A-6
MB991004
FRONT SUSPENSION –
STEERING ANGLE
Standard value:
CAMBER, CASTER AND KINGPIN INCLINATION
Standard value:
NOTE
1. Camber and caster are preset at the factory and cannot
2. If camber is not within the standard value, check and
3. For vehicles with aluminium type wheels, attach the
BALL JOINT DUST COVER CHECK
1. Check the dust cover for cracks or damage by pushing
2. If the dust cover is cracks or damaged, replace the lower
On-vehicle Service
Inner wheel 41 30'
Outer wheel 34 00'
Camber 0 40'
30'
Caster 2 54'
Kingpin inclination 13 36'
be adjusted.
replace bent or damaged parts.
camber/caster/kingpin gauge to the drive shaft by using
the special tool. Tighten the special tool to the same torque
216–255 Nm as the drive shaft nut.
Caution
Never subject the wheel bearings to the vehicle load
when the drive shaft nuts are loosened.
it with finger.
arm assembly.
NOTE
Cracks or damage of the dust cover may cause damage
of the ball joint.
33200860076