On-Vehicle Service; Front Wheel Alignment Check And Adjustment - Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement

FRONT SUSPENSION –

ON-VEHICLE SERVICE

FRONT WHEEL ALIGNMENT CHECK AND
ADJUSTMENT
Measure the wheel alignment with the vehicle parked on a
level surface.
The front suspension, steering system, and wheels should
be serviced to normal condition prior to measurement of wheel
alignment.
TOE-IN
Standard value:
NOTE
1. If the toe-in is not within the standard value, adjust the
Clip
2. The toe will move out as the left turnbuckle is turned toward
TOE-OUT ANGLE ON TURNS
To check the steering linkage, especially after the vehicle has
been involved in an accident or if an accident is presumed,
it is advisable to check the toe-out angle on turns in addition
to the wheel alignment.
Conduct this test on the left turn as well as on the right turn.
Standard value:
On-vehicle Service
At the centre of tyre tread 0
Toe angle (per wheel) 0 00'
toe-in by undoing the clips and turning the left and right
tie rod turn buckles by the same amount (in opposite
directions).
the front of the vehicle and the right turnbuckle is turned
toward the rear of the vehicle.
For each one turn of the left and right tie rods, the toe-in
will be adjusted by approx. 1 05' (per wheel).
21 39' (inner wheel when outer wheel at 20 )
33A-5
33100090212
2 mm
06'