MANUAL TRANSMISSION –
Oil temperature
sensor
Transmission oil
On-vehicle Service
OIL TEMPERATURE SENSOR CHECK
1. Remove the oil drain plug, and then drain the transmission
oil.
2. Remove the oil temperature sensor.
3. Measure the resistance between terminals 1 and 2 of
the oil temperature sensor connector.
Standard value:
Oil temperature ( C)
20
110
4. If the resistance is not within the standard value, replace
the oil temperature sensor.
5. Install the oil temperature sensor, and then tighten it to
the specified torque.
Tightening torque: 20 – 25 Nm
6. Install the drain plug and tighten it to the specified torque.
Supply a transmission oil. (Refer to P.22-4.)
22-5
22100670021
Resistance (kΩ)
2.31 – 2.59
0.145 – 0.149