Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 920

Link assembly
Wiper motor crank arm
A A
Front deck garnish end
EXTERIOR –
Windshield Wiper and Washer
REMOVAL SERVICE POINT
AA
Loosen the wiper motor assembly mounting bolts, and then
remove the wiper motor assembly. Disconnect the linkage
and the motor assembly, and then remove the linkage.
Caution
Because the installation angle of the crank arm and the
motor has been set, do not remove them unless it is
necessary to do so. If they must be removed, remove
them only after marking their mounting positions.
INSTALLATION SERVICE POINT
AA WIPER ARM AND BLADE ASSEMBLY
1. The movements of the left and right wiper arms are
2. Install the wiper blade in the specified position (standard
INSPECTION
COLUMN SWITCH CHECK
Wiper and Washer Switch
Switch position
Wiper switch
Washer switch
Intermittent
Inspection)
1. Connect the column switch connector.
2. Turn the ignition switch to ACC.
WIPER MOTOR REMOVAL
INSTALLATION
different, so check the identification marks.
value) as shown in the illustration.
Standard value:
Passenger's side (A): 20
Driver's side (B): 25
Terminal No.
OFF
INT
1 (LO)
2 (HI)
ON
Wiper Relay
5 mm
5 mm
6 7 8 9
(Intermittent
51-11
51100770035
10
Operation