Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 917

51-8
Fishing line
Double-sided tape
Double-sided tape
Adhesive
Resin spatula
EXTERIOR –
Moulding and Garnish
2. Insert fishing line [Ø0.8 mm] in between the body and the
moulding, and pull both ends alternately to cut the adhesive
section and remove the moulding.
Caution
(1) If the moulding is to be reused, pull the fishing
line along the edge of the body so as not to damage
the edge of the moulding.
(2) If the adhesive is difficult to remove, heat it to
40_C moulding has become warped, it should not
be reused.
3. Scrape off the double–sided tape with a resin spatula.
4. Peel off the protection tape.
5. Scrape off a small amount of the adhesive with a cutter
knife.
6. Wipe the body surface clean with a rag moistened with
isopropyl alcohol.
INSTALLATION SERVICE POINT
AA SIDE PROTECTOR MOULDING INSTALLATION
Affixing Double-sided tape to the mouldings (when reusing
mouldings)
1. Scrape off the double–sided tape with a resin spatula
or gasket scraper.
2. Wipe the moulding adhesion surface clean with a rag
moistened with isopropyl alcohol.
3. Affix the specified double-sided tape to the side protect
moulding. (Refer to P.51-7.)
Specified adhesive tape:
Double-sided tape
[12 mm wide and 0.8 mm thick]