Engine Control System; General Information; Service Specifications; On-Vehicle Service - Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement

ENGINE AND EMISSION CONTROL –

ENGINE CONTROL SYSTEM

GENERAL INFORMATION

A cable-type accelerator mechanism and a
suspended-type pedal have been adopted.

SERVICE SPECIFICATIONS

Items
Accelerator cable play mm
Engine idle speed r/min
NOTE
*: Varies depending on the transmission oil temperature For details refer to GROUP 11A – On-vehicle
Service.
<GDI>
5 Nm
<MPI>
5 Nm
Plate
GDI
MPI

ON-VEHICLE SERVICE

Adjusting bolts
ACCELERATOR CABLE CHECK AND
ADJUSTMENT
1. Turn A/C and lamps OFF.
2. Warm engine until stabilized at idle.
3. Confirm idle speed is at prescribed value.
Plate
Adjusting bolts
4. Stop engine (ignition switch OFF).
5. Confirm there are no sharp bends in accelerator cable.
6. Check inner cable for correct slack.
7. If there is too much slack or no slack, adjust play by the
Engine Control System
Standard value
1 – 2
600 50 – 800 50*
750 100
Inspect and adjust at no load.
Standard value:
<GDI> 600 50 – 800
<MPI> 750 100 r/min
NOTE
*: Varies depending on the transmission oil temperature
For details refer to GROUP 11A – On-vehicle Service.
Standard value: 1 – 2 mm
following procedures.
(1) Loosen the adjusting bolt to release the cable.
(2) Move the plate until the inner cable play is at the
standard value, and then tighten the adjusting bolt.
(3) After adjusting, check that the throttle lever is touching
the stopper.
17-3
17100010027
17100030160
17100090298
50 r/min*