ENGINE <4G6-MPI> -
2. Apply oil to the bearing surface of the flywheel or drive
3. Apply oil to the crankshaft thread holes.
4. Apply sealant to the threaded mounting holes.
5. Use the special tool to hold the flywheel or drive plate
"CA CRANKSHAFT FRONT OIL SEAL INSTALLATION
1. Apply a small amount of engine oil to the entire
2. Press-fit the oil seal unit it is flush with the oil seal case.
Crankshaft Oil Seal
plate bolts.
Specified sealant: 3M Stud locking 4170 or equivalent
in the same manner as removal, and install the bolt.
circumference of the oil seal lip.
11C-23