Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 921

51-12
Inspection while
operating
Low speed
High speed
Inspection while
stopped
Low speed
Automatic stop
UP
DOWN
EXTERIOR –
Windshield Wiper and Washer
3. Inspect the intermittent operation time when the wiper
WIPER MOTOR CHECK
Check the wiper motor after disconnecting the wiring harness
connector, and with the wiper motor remaining installed to
the body.
Wiper Motor at Low Speed and High Speed Operation
Connect a battery to the wiper motor as shown in the illustration
and inspect motor operation at low speed and high speed.
Wiper Motor at Stop Position Operation
Battery
1. Run the wiper motor at low speed, disconnect the battery,
2. Reconnect the battery as shown in the illustration, and
Battery
WASHER MOTOR CHECK
1. With the washer motor installed to the washer tank, fill
2. Check that the water squirts out strongly when battery
WASHER FLUID LEVEL SWITCH CHECK
1. Remove the washer fluid level switch from the washer
2. Connect a circuit tester to the connector of washer fluid
3. Move the float up and down.
4. Check to be sure that there is continuity between the
switch is turned to INT.
Vehicles with variable intermittent control
FAST: Approx. 3 seconds
SLOW: Approx. 12 seconds
and stop the motor.
confirm the after the motor starts turning at low speed,
it stops at the automatic stop position.
the washer tank with water.
voltage is applied to terminals (1) and (2).
tank.
level switch.
terminals when the float is down.
51101260135
51101270015
51101280018