Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 434

DATA LIST REFERENCE TABLE
Caution
When shifting the select lever to D range, the brakes should be applied so that the vehicle does
not move forward.
NOTE
1
* : Within four minutes after starting the engine
2
* : In a new vehicle [driven approximately 500 km or less], the injector drive time is sometimes 10% longer
than the standard time.
3
* : The accelerator pedal position switch normally turns off when the voltage of the accelerator pedal
position sensor (1st channel) is 50 – 100 mV higher than the voltage at the idle position. If the accelerator
pedal position switch turns back on after the accelerator pedal position sensor voltage has risen by
100 mV and the throttle valve has opened, the accelerator pedal position switch and the accelerator
pedal position sensor (1st channel) need to be adjusted.
Item Check items
No.
11 Oxygen sensor
12 Air flow sensor
13 Intake air tem-
perature sensor
14 Throttle position
sensor (2nd
channel) channel)
16 Power supply
voltage
GDI –
Requirements
Engine: After warm-
Idling
up up
Sudden racing
2,500 r/min
Engine coolant Idling
temperature:
80 – 95_C 80 95_C
2,500 r/min
Lamps, electric
cooling fan and cooling fan and
all accessories:
Racing
OFF
Transmission:
Neutral
Ignition switch: ON Intake air tempera-
ture: –20_C
Intake air tempera-
ture: 0_C
Intake air tempera-
ture: 20_C
Intake air tempera-
ture: 40_C
Intake air tempera-
ture: 80_C
Engine coolant
Release the acceler-
temperature: 80 ator pedal.
– 95_C 95_C
Depress the acceler-
Ignition switch:
ator pedal gradually.
ON (Engine
stopped) )
Depress the acceler-
ator pedal fully.
Ignition switch: ON
Troubleshooting
Normal condition
0 mV
600 – 1,000 mV
400 mV or less and
600 – 1,000 mV
alternates.
20 – 55 Hz
65 – 85 Hz
Frequency
creases in response
to racing.
–20_C
0_C
20_C
40_C
80_C
4,200 – 4,800 mV
Voltage decreases
in response to the
pedal depression.
200 – 900 mV
System voltage
13A-75
Inspection Reference
procedure page
No.
Code 13A-14
No.11 No 11
Code 13A-15
No.12
in-
Code 13A-16
No.13
Code 13A-17
No.14
Procedure 13A-65
No.25