Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 853

42-10
MB990449
MB990480
BODY –
Window Glass
REMOVAL SERVICE POINTS
AA
ROOF DRIP MOULDING REMOVAL
Use the special tool to lever out the moulding.
Caution
If the moulding has become warped, it should not be
reused.
AB
WINDSHIELD REMOVAL
1. In order to protect the body (paint surface), apply cloth
tape to all body areas around the installed windshield.
2. Using a sharp-point drill, make hole in the windshield
adhesive.
3. Pass the piano wire from the inside of the vehicle through
the hole.
4. Pull the piano wire alternately from the inside and outside
along the windshield to cut the adhesive.
Caution
Do not let the piano wire touch the edge of the
windshield.
5. Make mating marks on the windshield and body.
6. Use the special tool to remove the windshield.
7. Use a knife to cut away the remaining adhesive so that
the thickness is within 2 mm around the entire
circumference of the body flange.