13B-72
Throttle position sensor
MPI –
On-vehicle Service
2. With temperature sensing portion of engine coolant
3. If the resistance deviates from the standard value greatly,
4. Apply sealant to threaded portion.
5. Install the engine coolant temperature sensor and tighten
THROTTLE POSITION SENSOR CHECK
Equipment
side connector
1. Disconnect the throttle position sensor connector.
2. Measure the resistance between the throttle position
3. Measure the resistance between the throttle position
4. If the resistance is outside the standard value, or if it doesn't
temperature sensor immersed in hot water, check
resistance.
Standard value:
2.1 – 2.7 kΩ (at 20 C)
0.26 – 0.36 kΩ (at 80 C)
replace the sensor.
Specified sealant:
3M NUT Locking Part No.4171 or equivalent
it to the specified torque.
Tightening torque: 29 Nm
sensor side connector terminal 1 and terminal 4.
Standard value: 3.5–6.5 kΩ
sensor side connector terminal 2 and terminal 4.
Normal condition:
Throttle valve slowly open
until fully open from the idle
position
change smoothly, replace the throttle position sensor.
NOTE
For the throttle position sensor adjustment procedure, refer
to P.13B-65.
13100320412
Changes smoothly in
proportion to the opening
angle of the throttle valve