Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 456

Accelerator pedal position
sensor (equipment connector)
Accelerator pedal position sensor
Accelerator pedal
position sensor
Stopper (full stop
Accelerator lever
position)
View
A
Accelerator
lever
Thickness
gauge
Stopper (full
stop position)
GDI –
On-vehicle Service
6. Check the output voltage of the throttle position sensor
(2nd channel) when the throttle valve is fully closed by
your finger.
Standard value: 4.2 – 4.8 V
7. If not within the standard value, replace the throttle position
sensor.
8. Turn off the ignition switch.
9. Reconnect the throttle valve control servo connector.
10. Remove the MUT-II.
11. If a diagnosis code is displayed, erase the diagnosis code
by using the MUT-II or disconnect the negative battery
cable from the battery terminal and then leave it for at
least ten seconds. After that, reconnect the battery cable.
12. Turn on the ignition switch, wait for at least 10 seconds,
and then off again. In addition, if the battery cable is
disconnected at step 11, let the engine run at idle for
approx. ten minutes.
ACCELERATOR PEDAL POSITION SWITCH
AND ACCELERATOR PEDAL POSITION
SENSOR ADJUSTMENT
Caution
1. Never attempt to tamper the accelerator pedal position
sensor. The sensor position is precisely adjusted at
factory.
2. Should it be tampered, follow the procedure below:
1. Connect the MUT-II to the diagnosis connector.
2. Remove the two accelerator pedal position sensor
assembly mounting bolts, and then insert a 0.60 mm of
thickness gauge blade between the accelerator lever and
stopper.
3. Turn on the ignition switch (but do not start the engine).
A
Accel-
erator
pedal
position
sensor
13A-97