Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 882

Hide thumbs Also See for Space Runner 1999:

Table of Contents

Lifting wire

2. Pass the springs over the wires, and then install the

lowering wire to the guide first, followed by the lifting wire.

(The lifting wire should be on top of the lowering wire.)

3. Use some narrow-gauge wire (approx. 0.5 mm diameter)

to compress the springs.

Tie the narrow-gauge wires to the slits in the guide.

4. Insert the end of the lowering wire into the wire hole at

the bottom of the drum, and then wrap the wire securely

around the groove of the drum from the bottom so that

there is no slackness in the wire.

5. Install the lifting wire to the drum as follows:

(1) Insert the end of the lifting wire into the wire hole

(2) Raise the front of the drum until the drum is vertical,

at the top of the drum.

and then position the lifting wire in the groove of the

Show Quick Links

Chapters

Table of Contents