Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 978

Lock lever
SRS warning lamp
SRS –
SRS-ECU
INSTALLATION SERVICE POINTS
AA SRS-ECU INSTALLATION
Caution
The SRS may not activate if SRS-ECU is not installed
properly, which could result in serious injury or death
to the vehicle's driver or front passenger.
BA HARNESS CONNECTOR CONNECTION
Connect the harness-side connector securely to the SRS-ECU
connector, and then turn the lock lever in the direction of the
arrow to lock the connector.
CA POST-INSTALLATION INSPECTION
1. Reconnect the negative battery terminal.
2. Turn the ignition key to the "ON" position.
3. Does the "SRS" warning lamp illuminate for about 7
seconds, and then remain extinguished for at least 5
seconds after turning OFF?
4. If yes, SRS system is functioning properly.
If no, consult page 52B-7.
INSPECTION
D
Check the SRS-ECU and brackets for dents, cracks or
deformation.
D
Check connector
deformation.
Caution
If a dent, crack, deformation or rust is discovered,
replace the SRS-ECU with a new one.
NOTE
For checking of the SRS-ECU other than described above,
refer to the section concerning troubleshooting. (Refer
to P.52B-7.)
for damage, and terminals
52B-29
52400220208
for