MANUAL TRANSMISSION –
Transmission mount stopper
NOTE
Because there are an odd number of splines on the drive
shaft, the pin hole will be off-line by half the width of the
hole if the drive shaft is turned 180_.
2. Apply specified sealant to the spring pin, and then insert
it into the drive shaft.
Specified sealant:
3. After inserting the pin, apply sealant to both ends of the
pin hole to fully seal the hole.
Specified sealant:
BA STABILIZER BAR INSTALLATION
Tighten the self-locking nut so that the stabilizer bar mounting
bolt protrudes as shown.
A
Standard value (A): 22 mm
CA TRANSMISSION MOUNT STOPPER INSTALLATION
Engine side
Install the transmission mount stopper so that the arrow points
as shown in the illustration.
Transmission Assembly <F5MR1>
MITSUBISHI
GENUINE
equivalent
MITSUBISHI
GENUINE
equivalent
22-15
PART
MD970389
or
PART
MD970389
or