Front Disc Brake Pad Check And Replacement - Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement

BASIC BRAKE SYSTEMS –
When new
Pad
Brake disc
Wear indicator
2
1
FRONT DISC BRAKE PAD CHECK AND
When worn
REPLACEMENT
NOTE
The brake pads have wear indicators that contact the brake
disc when the brake pad thickness becomes 2 mm and emit
a squealing sound to warn the driver.
1. Check brake pad thickness through caliper body check
2. Remove lock pin. Lift caliper assembly and retain with
3. Remove the following parts from caliper support.
3
4. In order to measure the brake drag torque after pad
5. Install the pads and the caliper assembly, and then check
On-vehicle Service
port.
Standard value: 10 mm
Limit: 2.0 mm
Caution
(1) When the limit is exceeded, replace the pads at
both sides, and also the brake pads for the wheels
on the opposite side at the same time.
(2) If there is a significant difference in the thickness
of the pads on the left and right sides, check the
sliding condition of the piston, lock pin and guide
pin.
wires.
Caution
Do not wipe off the special grease that is on the lock
pin or allow it to contaminate the lock pin.
1. Pad & wear indicator assembly
2. Pad assembly
3. Outer shim
installation, measure the rotary-sliding resistance of the
hub (A) with the pads removed. (Refer to P.35A-20.)
the brake drag torque. (Refer to P.35A-20.)
35A-11
35100150228