Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 308

MD998781
Crankshaft
rear oil seal
MD990938
MD998776
Crankshaft
MD998717
MD998717
Oil seal
ENGINE <4G9> –
REMOVAL SERVICE POINT
AA
Use the special tool to secure the flywheel, and remove the
bolts.
INSTALLATION SERVICE POINTS
AA CRANKSHAFT REAR OIL SEAL INSTALLATION
Crankshaft
1. Apply a small mount of engine oil to the entire
circumference of the oil seal lip.
2. Install the oil seal by tapping it as far as the chamfered
position of the oil seal case as shown in the illustration.
BA ADAPTOR PLATE/FLYWHEEL ASSEMBLY/PLATE
1. Clean off all sealant, oil and other substances which are
adhering to the threaded bolts, crankshaft thread holes
and the flywheel.
2. Apply oil to the bearing surface of the flywheel bolts.
3. Apply oil to the crankshaft thread holes.
4. Apply sealant to the threaded mounting holes.
Specified sealant: 3M Stud locking 4170 or equivalent
5. Use the special tool to secure the flywheel, and then tighten
the bolts to the specified torque.
Specified torque: 93 – 103 Nm
CA CRANKSHAFT FRONT OIL SEAL INSTALLATION
1. Apply a small amount of engine oil to the entire
circumference of the oil seal lip.
2. Tap the oil seal unit it is flush with the oil seal case.
Crankshaft Oil Seal
PLATE/ADAPTOR PLATE/FLYWHEEL REMOVAL
INSTALLATION
11A-25