Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 624

<GDI>
S
M
<MPI>
Battery
S
<GDI>
S
<MPI>
Battery
S
ENGINE ELECTRICAL –
5. If pinion gap is out of specification, adjust by adding or
MAGNETIC SWITCH PULL-IN TEST
1. Disconnect field coil wire from M-terminal of magnetic
2. Connect a 12V battery between S-terminal and M-terminal.
Battery
Wire
3. If pinion moves out, then pull-in coil is good. If it doesn't,
M
Wire
MAGNETIC SWITCH HOLD-IN TEST
1. Disconnect field coil wire from M-terminal of magnetic
2. Connect a 12V battery between S-terminal and body.
Battery
Wire
3. Manually pull out the pinion as far as the pinion stopper
4. If pinion remains out, everything is in order. If pinion moves
Wire
Starting System
removing gaskets between magnetic switch and front
bracket.
switch.
Caution
This test must be performed quickly (in less than 10
seconds) to prevent coil from burning.
replace magnetic switch.
switch.
Caution
This test must be performed quickly (in less than 10
seconds) to prevent coil from burning.
position.
in, hold-in circuit is open. Replace magnetic switch.
16-25