Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 985

52B-36
SRS warning lamp
SRS – Side Impact Sensor
INSTALLATION SERVICE POINTS
AA PRE-INSTALLATION INSPECTION
Check the side impact sensor for dents, breakage and measure
the resistance between the terminals, even when installing
a new side impact sensor.
BA SIDE IMPACT SENSOR INSTALLATION
Securely connect the connector.
Center
pillar Caution
If the side impact sensor is not installed securely and
correctly, te side air bag may not operate normally.
CA POST-INSTALLATION INSPECTION
1. Reconnect the negative battery terminal.
2. Turn the ignition key to the "ON" position.
3. Does the "SRS" warning lamp illuminate for about 7
seconds, and then remain extinguished for at least 5
seconds after turning OFF?
4. If yes, SRS system is functioning properly. If no, consult
page 52B-7.
INSPECTION
SEAT BELT WITH PRE-TENSIONER CHECK
D
Check the side impact sensor and bracket for dents, cracks
or deformation.
D
Check
deformation.
Caution
If a dent, crack, deformation or rust is discovered,
replace the side impact sensor with a new one.
NOTE
For checking of the side impact sensor other than described
above, refer to the section concerning troubleshooting.
(Refer to P.52B-7.)
D
Check that there is no bending or corrosion in the center
pillar.
connector for damage,
52400470030
and terminals for