Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 99

13D-34
From the previous page.
MUT-II Data list
59 Oxygen sensor (rear) (Refer to P.13D-62.)
D Transmission: 2nd gear <M/T>, L range <A/T>
D Driving with throttle widely open
OK: 600 - 1,000 mV
MUT-II Data list
11 Oxygen sensor
OK: 600 - 1,000 mV during sudden racing
MUT-II Data list
11 Oxygen sensor
OK: Changes between 0 - 400 mV and 600 - 1,000 mV during
idling
MUT-II Data list
27 Power steering fluid pressure switch (Refer to P.13D-60.)
MUT-II Data list
28 A/C switch (Refer to P.13D-60.)
MUT-II Data list
29 Inhibitor switch (Refer to P.13D-60.)
MUT-II Data list
45 ISC Servo position (Refer to P.13D-61.)
Check the ignition timing.
(Refer to GROUP 11A - On-vehicle Service.)
Check the following items.
D Check the ignition coil, spark plugs, spark plug cables.
D Check the purge control system.
D Check the EGR control system.
D Check the compression pressure.
D Check if foreign materials (water, alcohol, etc.) got into fuel.
MPI -
OK
OK
OK
OK
OK
OK
OK
OK
OK
Troubleshooting
NG
Check the oxygen sensor (rear) system. (Refer to P.13D-24, IN-
SPECTION PROCEDURE FOR DIAGNOSIS CODE 59.)
NG
Check the oxygen sensor (front) system. (Refer to P.13D-12, IN-
SPECTION PROCEDURE FOR DIAGNOSIS CODE 11.)
NG
Check the fuel pressure.
(Refer to P.13D-82.)
NG
Check the power steering
fluid pressure switch sys-
tem. (Refer to P.13D-54,
INSPECTION PROCE-
DURE 32.)
NG
Check the A/C switch and A/C relay system.
(Refer to P.13D-54. INSPECTION PROCEDURE 33.)
NG
Check the ignition switch-ST and inhibitor switch system. <A/T>
(Refer to P.13D-53, INSPECTION PROCEDURE 31.)
NG
Adjust the basic idle speed. (Refer to P.13D-81.)
NG
Check that the crank angle sensor is installed properly.
OK
1. Inspect the intake of
air into the air intake
system.
D Broken intake
manifold gasket
D Broken vacuum
hose
D PCV valve does
not operate.
D Broken air intake
hose
2. Check the injector for
clog.