Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 310

Removal steps
1. Injector harness connector
2. Front exhaust pipe connection
3. Exhaust manifold bracket
4. Power steering oil pump bracket
stay
AA
5. Power steering oil pump and brack-
et assembly
MB991653
Intake side Front of engine
3 5 10
1 7 9
Exhaust side
ENGINE <4G9> –
REMOVAL SERVICE POINTS
AA
Remove the power steering oil pump and bracket assembly
from the engine with the hose attached.
NOTE
Place the removed power steering oil pump in a place where
it will not be a hindrance when removing and installing the
cylinder head assembly, and tie it with a cord.
AB
Use the special tool to loosen the bolts in two or three stages
in the order of the numbers shown in the illustration, and
then remove the bolts.
8 2
6 4
INSTALLATION SERVICE POINTS
1. Wipe off all oil and grease from the gasket mounting
2. Install so that the shapes of the cylinder head holes match
Cylinder Head Gasket
6. Idler pulley
7. Timing belt rear cover
8. Engine oil level gauge assembly
9. Rocker cover
AB
BA 10. Cylinder head bolt
11. Cylinder head assembly
AA 12. Cylinder head gasket
POWER STEERING OIL PUMP AND BRACKET
ASSEMBLY REMOVAL
CYLINDER HEAD BOLT REMOVAL
AA CYLINDER HEAD GASKET INSTALLATION
surface.
the shapes of the respective cylinder head gasket holes.
11A-27