Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 319

11A-36
MB991453
ENGINE <4G9> –
REMOVAL SERVICE POINTS
AA
Remove the power steering oil pump and bracket assembly
from the engine with the hose attached.
NOTE
Place the removed power steering oil pump where it will not
be a hindrance when removing and installing the engine
assembly, and tie it with a cord.
AB
Disconnect the A/C compressor connector and remove the
compressor from the compressor bracket with the hose still
attached.
NOTE
Place the removed A/C compressor where it will not be a
hindrance when removing and installing the engine assembly,
and tie it with a cord.
AC
MZ203827
1. Support the engine with a garage jack.
2. Remove the mechanical hanger (recommended tool) which
was attached when the transmission assembly was
removed.
3. Hold the engine assembly with a chain block or similar
tool.
4. Place a garage jack against the engine oil pan with a
piece of wood in between, jack up the engine so that
the weight of the engine is no longer being applied to
the engine mount bracket, and then remove the engine
mount bracket.
AD
After checking that all cables, hoses and harness connectors,
etc., are disconnected from the engine, lift the chain block
slowly to remove the engine assembly upward from the engine
compartment.
INSTALLATION SERVICE POINTS
AA ENGINE ASSEMBLY INSTALLATION
Install the engine assembly, checking that the cables, hoses,
and harness connectors are not clamped.
Engine Assembly
POWER STEERING OIL PUMP AND BRACKET
ASSEMBLY REMOVAL
A/C COMPRESSOR REMOVAL
ENGINE MOUNT BRACKET REMOVAL
ENGINE ASSEMBLY REMOVAL