Fixed Sas Adjustment - Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement

13D-80
<Vehicles without auto-cruise control system>
Throttle lever
Thick-
ness
Fixed
gauge
SAS
Fixed SAS
Fixed SAS
MPI -
On-vehicle Service
2. Insert a thickness gauge as follows:
Insert a thickness gauge with a thickness of 0.45 mm
between the fixed SAS and the throttle lever.
NOTE
Do not insert the thickness gauge 3 mm or more. If doing
that, the throttle lever opening angle becomes larger than
the predetermined angle, causing maladjustment.
3. Turn the ignition switch to ON (but do not start the engine).
4. Loosen the throttle position sensor mounting bolt, and
then turn the throttle position sensor anti-clockwise as
far as it will go.
5. Check that the idle position switch is ON at this position.
6. Slowly turn the throttle position sensor clockwise and
find the point where the idle position switch turns off.
Securely tighten the throttle position sensor mounting
bolt at this point.
7. Check the throttle position sensor output voltage.
Standard value: 400 - 1,000 mV
8. If there is a deviation from the standard value, check
the throttle position sensor and the related harness.
9. Remove the thickness gauge.
10. Turn the ignition switch to "LOCK" (OFF) position.
11. Disconnect the MUT-II.

FIXED SAS ADJUSTMENT

NOTE
(1) The fixed SAS should not be moved unnecessarily;
it has been precisely adjusted by the manufacturer.
(2) If the adjustment is disturbed for any reason, readjust
as follows.
1. Loosen the tension of the accelerator cable sufficiently.
2. Back out the fixed SAS lock nut.
3. Turn the fixed SAS counterclockwise until it is sufficiently
backed out, and fully close the throttle valve.
4. Tighten the fixed SAS until the point where the throttle
lever is touched (i.e., the point at which the throttle valve
begins to open) is found.
From that point, tighten the fixed SAS 1-1/4 turn.
5. While holding the fixed SAS so that it doesn't move, tighten
the lock nut securely.
6. Adjust the tension of the accelerator cable.
7. Adjust the basic idling speed.
8. Adjust the idle position switch and the throttle position
sensor (P.13D-79).