ENGINE ELECTRICAL –
Wire
Rear bracket
Brush
Wire
Wire
Charging System
REASSEMBLY SERVICE POINTS
AA REGULATOR ASSEMBLY INSTALLATION
After installing the regulator assembly, insert a wire into the
hole provided on the rear bracket while pressing in the brush
to fix the brush.
NOTE
The brush is fixed when a wire is inserted, making rotor
installation easier.
BA ROTOR INSTALLATION
After installing the rotor, remove the wire used to fix the brush.
INSPECTION
ROTOR CHECK
1. Check the continuity between the rotor coil slip rings, and
replace the rotor if the resistance value is not at the
standard value.
Standard value: 2 – 5 Ω
2. Check the continuity between the slip ring and core, and
if there is continuity, replace the rotor.
16-17
16100170216