Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 695

22-14
MANUAL TRANSMISSION –
MB991453
MB990635 or
MB991113
Nut
Ball joint
AB
Remove the clutch release cylinder without disconnecting the
oil line connection, and fix it to the vehicle chassis.
AC
Jack up the transmission assembly gently with a garage jack,
and then remove the transmission mount bracket.
AD
MZ203827
Set the special tool to the vehicle to support the engine
assembly.
AE
Caution
1. Use the special tool to loosen the tie-rod end mounting
Cord
2. Support the special tool with a cord, etc. not to let
AF
1. Remove the drive shaft with the hub and knuckle, etc.,
2. Suspend the removed drive shaft inside the wheel housing
INSTALLATION SERVICE POINTS
AA DRIVE SHAFT <R.H.>/SPRING PIN INSTALLATION
1. After applying multipurpose grease to the transmission-
Transmission Assembly <F5MR1>
CLUTCH RELEASE CYLINDER REMOVAL
TRANSMISSION MOUNT BRACKET REMOVAL
ENGINE ASSEMBLY SUPPORTING
TIE ROD END/LOWER ARM BALL JOINT
DISCONNECTION
nut. Only loosen the nut; do not remove it from the
ball joint.
it come off.
DRIVE SHAFT <L.H.> REMOVAL
still attached.
with wire so that there are no sharp bends in any of the
joints.
side spline of the drive shaft, align the spring pin hole
at the end of the drive shaft with the spring pin hole at
the end of the shaft at the transmission side, and then
install the drive shaft.
If the spring pin hole is slightly off-line, turn the drive shaft
180_ and then install it again.