ENGINE ELECTRICAL –
Free
Lock
Brush
length
Starting System
INSPECTION
OVERRUNNING CLUTCH
1. While holding clutch housing, rotate the pinion. Drive pinion
should rotate smoothly in one direction, but should not
rotate in opposite direction. If clutch does not function
properly, replace overrunning clutch assembly.
2. Inspect pinion for wear or burrs. If pinion is worn or burred,
replace overrunning clutch assembly. If pinion is damaged,
also inspect ring gear for wear or burrs.
BRUSH
1. Check the brush length.
Limit: 11 mm
16-33
16200130118