ENGINE MOUNTING
REMOVAL AND INSTALLATION
Caution
Mounting locations marked by * should be provisionally tightened, and then fully tightened when
the body is supporting the full weight of the engine.
Pre-removal Operation
Jack Up the Engine and Transmission Assembly Until
There is no Weight on the Engine Mount Bracket
Insulator.
2
Removal steps
1. Power steering pressure hose
mounting bolt
2. Engine mount insulator mounting
bolt
Front side
POWER PLANT MOUNT –
4
INSTALLATION SERVICE POINT
Rear side
AA ENGINE MOUNT STOPPER INSTALLATION
1. At the front, install so that the arrow with the "F" mark
2. At the rear, install so that the arrow with the "R" mark
Engine Mounting
1
3
88 Nm*
3. Engine mount bracket
AA 4. Engine mount stopper
is facing upward.
is facing upward.
49 Nm
4
32-3
32100010379